Fisher 1270 Bedienungsanleitung

1270 Operating ManualSpecial Anniversary Edition Metal DetectorFISHER RESEARCH LABORATORYQ U A L I T YFisher detectors are renowned for their qualit

10IRON DISC MODEany metal. This may be tested quickly by pulling the trigger switch and sweeping over an area of about one square foot. If no signal

CONTENTSAbout Your Detector ...pg. 3Condensed Operating Instructions ...

ABOUT YOUR FISHER 1270The 1270 is a “motion” detector and was designed to offer you more versatility in a wide range of conditions: Highly mineralized

NOTES1. Subject to modication without notice.2. Approximate.3. PULSEGATE UNIPOLAR AUDIO PROCESSING. Advanced Fisher circuitry which allows silent o

SETTING UPYour new 1270 comes ready to assemble, set and use, but rst review the steps below before proceeding.STEP 1. Unpack your 1270 carefull

STEP 5. Adjust the length and the coil angles so that the search coil rests at on the ground about 12 inches in front of your foot. Your arm should b

CONTROLS & FUNCTIONS71. ON / OFF VOLUME: ON /OFF VOLUME: Allows you turn on the 1270 and adjust the volume to a comfortable level. No need to have

86. IRON DISC TOGGLE: When this toggle switch is ipped ON, the 1270 will operate in IRON DISC mode. When operating in this mode, the IRON DISC contr

9ALL METAL MODEYour 1270 gives you two ways to search in all-metal operation: (1) by set-ting your NORMAL DISC to 0, or (2) by turning on the ALL META